1. Show me how you would check that the direction indicators
are working.
Applying the indicators or hazard warning switch and check functioning of all
indicators.
2. Tell me how you would check that the brakes are working before
starting a journey.
Brakes should not feel spongy or slack. Brakes should be tested as you set off.
Vehicle should not pull to one side.
3. Identify where the windscreen washer reservoir is and tell
me how you would check the windscreen washer level.
Identify reservoir and explain how to check level.
4. Show me how you would check that the brake lights are working
on this car. (I can assist you, if you need to switch the ignition on, please
don't start the engine)
Operate brake pedal, make use of reflections in windows, garage doors, etc,
or ask someone to help.
5. Show me / explain how you would check that the power assisted
steering is working before starting a journey.
If the steering becomes heavy the system may not be working properly. Before
starting a journey two simple checks can be made. Gentle pressure on the steering
wheel, maintained while the engine is started, should result in a slight but
noticeable movement as the system begins to operate. Alternatively turning the
steering wheel just after moving off will give an immediate indication that
the power assistance is functioning.
6. Tell me where you would find the information for the recommended
tyre pressures for this car and how tyre pressures should be checked.
Manufacturer’s guide, use a reliable pressure gauge, check and adjust pressures
when tyres are cold, don’t forget spare tyre, remember to refit valve caps.
7. Show me how you would check the parking brake (handbrake)
for excessive wear, make sure you keep safe control of the vehicle.
Apply footbrake firmly. Demonstrate by applying parking brake (handbrake) so
that when it is fully applied it secures itself, and is not at the end of the
working travel.
8. Open the bonnet, identify where you would check the engine
oil level and tell me how you would check that the engine has sufficient oil.
Identify dipstick / oil level indicator, describe check of oil level against
the minimum/maximum markers.
9. Open the bonnet, identify where you would check the engine
coolant level and tell me how you would check that the engine has the correct
level.
Identify high/low level markings on header tank where fitted or radiator filler
cap, and describe how to top up to correct level.
10. Tell me how you make sure your head restraint is correctly
adjusted so it provides the best protection in the event of a crash.
The head restraint should be adjusted so the rigid part of the head restraint
is at least as high as the eye or top of the ears, and as close to the back
of the head as is comfortable. N.B. Some restraints might not be adjustable.
11. Open the bonnet, identify where the brake fluid reservoir
is and tell me how you would check that you have a safe level of hydraulic brake
fluid.
Identify reservoir, check level against high/low markings.
12. Tell me how you would check the tyres to ensure that they
have sufficient tread depth and that their general condition is safe to use
on the road.
No cuts and bulges, 1.6mm of tread depth across the central ¾ of the breadth
of the tyre and around the entire outer circumference.
13. Show me how you would check that the horn is working (off
road only).
Check is carried out by using control (turn on ignition if necessary).
14. Show me how you would clean the windscreen using the windscreen
washer and wipers.
Operate control to wash and wipe windscreen (turn ignition on if necessary.
15. Tell me how you would check that the headlights & tail lights
are working. (No need to exit vehicle).
Explanation: Operate switch (turn on ignition if necessary), then walk round
vehicle. (As this is a "Tell Me" question, there is no need to physically check
the lights).
16. Show me how you would set the demister controls to clear
all the windows effectively, this should include both front and rear screens.
Set all relevant controls including; fan, temperature, air direction / source
and heated screen to clear windscreen and windows. Engine does not have to be
started for this demonstration.
17. Show me how you would switch on the rear fog light(s) and
explain when you would use it/them. (No need to exit vehicle)
Operate switch (turn on dipped headlights and ignition if necessary). Check
warning light is on. Explain use.
18. Tell me how you would know if there was a problem with your
anti lock braking system.
Warning light should illuminate if there is a fault with the anti lock braking
system.
19. Show me how you switch your headlight from dipped to main
beam and explain how you would know the main beam is on whilst inside the car
Operate switch (with ignition or engine on if necessary), check with main beam
warning light.